Frigidaire FGX831FS0 Washer/Dryer Combo Parts

Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.

Dryer drum glide. These drum glides help to support the front of the dryer drum as it rotates. Sold individually. It is recommended to replace both at one time.

Your dryer has two drum glides. Because the drum glides wear out at the same time, we recommend replacing them together.

Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

Dryer thermal limiter (or thermal fuse). May be located on the blower housing or element. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced

Washer drive belt. If this belt is broken, the washer will not spin or agitate.

The tension pulley may also be worn.

Washing machine drain pump. On some models you will need to configure the replacement pump to match the old pumps outlet port direction and reuse the old mounting bracket. If the washer does not drain then the drain pump may be clogged, damaged, or defective.

Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.

Lower felt for drum seal

Bearing cup for drum support ball

Idler pulley and arm, dryer

The Frigidaire Blower Wheel 131476300 is a high-quality part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. Recommended to use safety equipment. Disconnect the appliance before repair. Consult the owner's manual for instructions.

The high quality Frigidaire Control Knob (131873304 ) allows for control cycle settings. The Control Knob knob is easy to remove by pulling it straight off its post and is approximately 2.5 inches in diameter. Please be aware that it is recommended to use saftey equipment and to disconnect the appli

Upper seal for drum seal